
CP 21
FIXED INCLINE CONVEYOR WITH DIRECTION CHANGE
- Anodized ALU profile structure (thickness 15 Microns) Alloy 6060 with h 65 mm built-in non-removable side panels
- Sturdy conveyor featuring 40° fixed incline angle in the standard configuration; also available with 30°, 50°, 60° fixed incline angle
- Standard cut-proof, oil-proof belt with smooth green Polyurethane covering (ref. Pantone 320) and h 30 mm slats at 400 mm pitch; vulcanized belt joint
- Belt details:
– Hardness of PU cover: 92 Shore
– Contact temperature: -10 +110°C
– Operating temperature: -10 +90°C
- Power: 0,12 kW
- Speed: 4,5 m/min fixed
- Voltage: 400 V / 50 Hz
- Std installation: on left-hand side with fixed drive and shaft-mounted flange
- Worm reduction gear ratio 1:80 with life-long lubrication
IMM
250/500 t and PET
STANDARD DIMENSIONAL FEATURES

CONFIGURATIONS

CONVEYOR MOD. CP 21
- The CP 21 conveyor in the photo alongside is very wide/long, thus preferable to the N series. Note the dust guard over both the flat section and upward section

CONVEYOR MOD. CP 21 WITH CENTRAL PARTITION
- In this photo, a large CP 21 conveyor is equipped with a central partition in 10 mm thick Delrin
- The central partition is fastened to supports, allowing its height to be adjusted in relation to the belt surface
- Owing to the central partition, there are no heat-welded slats at the belt centre for 30 mm

CP 21 FDA WITH SHUTTER HOPPER
- An FDA version of conveyor mod. CP 21 is shown in this photo
- Besides the Polycarbonate dust guard, note the hopper that accumulates product leaving the mould
- The hopper accumulates product as it drops from the mould by means of a pneumatically controlled openable damper

CONVEYING SYSTEM FORMED BY CPT 21 AND CP 21
- The photo alongside is of a system where two 21 series conveyors square to each other collect product under the press and convey it to the storage container
- The side panels, hopper and chutes are made of AISI 304 stainless steel
Category: Conveying