N-CPTR
CONVEYOR WITH DIRECTION CHANGE
- Anodized ALU profile structure (thickness 15 Microns) Alloy 6060 with h 50 mm built-in non-removable side panels
- Standard configuration with central base complete with gas pistons and padlockable switch/motor protector + cable and plug
- Standard cut-proof, oil-proof belt with smooth green Polyurethane covering (ref. Pantone 320) and h 30 mm heat-welded slats at 400 mm pitch; vulcanized belt joint.
- Belt details:
– Hardness of PU cover: 92 Shore
– Contact temperature: -10 +110°C
– Operating temperature: -10 +90°C - NOTE : Dim. Max B+C+D = 6000 mm
- Power: 0,12 kW
- Speed: 4.5 m/min fixed
- Voltage: 400 V / 50 Hz
- Std installation: on left-hand side with fixed drive and shaft-mounted flange
- Worm reduction gear with life-long lubrication
Machine sizing sheets
IMM
80/250 t
STANDARD DIMENSIONAL FEATURES
EXAMPLES OF POSITIONING BESIDE IMM
P1 - STANDARD LATERAL POSITION
P2 - POSITIONING AT RIGHT-ANGLES UNDER PRESS
P3 - LONGITUDINAL POSITIONING UNDER PRESS
CONFIGURATIONS
N-CPTR CONVEYOR IN EASY LINE VERSION
- Compared to the standard line, the Easy Line version has simple but functionally designed supporting legs that still allow the angle of the sloping section and the height of the conveyor to be adjusted with the same parameters as the standard solution, where gas pumps are included
N-CPTR CONVEYOR
- The technical-dimensional characteristics of the mod. N-CPTR Easy Line conveyor in the photo alongside allow it to be installed in a longitudinal position inside the press
- The Polycarbonate guards protect the production as it is conveyed, while the hopper contains and channels the product as it drops from the mould into the conveyor
N-CPTR OUTLET CHUTE WITH GUARD
- This photo illustrates the outlet chute installed on the conveyor with its Polycarbonate dust guard
- Not only does the chute guard protect the product as it is conveyed, but also in the section where it leaves the conveyor
CONVEYOR MOD. N-CPTR
- The conveyor in the photo at the top has belts with central partitions formed by the Spondaflex
- This is a good solution when Bi-injection presses are used, since it allows the products from two different moulds to remain separate. These presses are usually used to make the same product but with right-hand and left-hand characteristics
- Mod. N-CPRT conveyors can be fitted with 30 mm maximum height “Bande Board”
Category: Conveying